Precision-engineered rear suspension upgrade delivering controlled damping and direct bolt-in fitment for lifted 2024–2026 Toyota Tacomas.

These ICON 2.5 Series shock absorbers replace worn OEM components with race-caliber valve trains and billet construction, restoring ride control while supporting 1.25-inch to 3-inch lift configurations.

• Guaranteed Platform Match: Compatible strictly with 2024, 2025, and 2026 Tacoma four-wheel-drive frames, replicating factory mounting eye-to-eye spacing so installers swap them without cutting brackets or fabricating new subframes.
• Lift-Specific Valving: Factory-tuned for progressive ride heights between 1.25″ and 3″, compensating for altered track bar and toe-link angles to eliminate bump-steer and keep steering geometry predictable at loaded and static settings.
• Billet Aluminum & Hardened Shaft Core: CNC-machined aluminum outer barrels house chromoly pistons and nitride-coated guide rods, resisting impact denting and preventing salt-induced corrosion along coastal trails.
• Tuned Bump Control: Optimized low-speed compression circuitry absorbs consecutive square-edged ruts and hard braking forces, drastically reducing rear-end chatter and trailer sway during steep descents.
• Load & Tow Capacity: Paired with matching suspension components, these units shoulder typical aftermarket rigs including winch plates, side steps, and rooftop tents without progressive droop that misaligns headlights or strains frame rails.
• Field Maintenance Access: External bleed valves and tool-ready preload rings let owners purge trapped air or retune rebound stiffness in minutes using basic metric sockets, extending service intervals across seasonal rotations.
• Factory Warranty Protection: Covered by a limited manufacturer warranty against seal failures and machining defects under normal recreational off-road use, with direct technical support channels for complex build troubleshooting.