Baja Designs Upfitter Wiring Harness for LP4 & LP6 – Plug-and-Play 5-Light Control Kit

Streamline your off-road lighting installation with a dedicated 12-volt power distribution system engineered exclusively for Baja Designs LP series modules, delivering stable current without custom fabrication.

• Five-light capacity supported by a 30-amp relay bank and individual inline blade fuses safeguards each LED pod against voltage spikes while consolidating connections into a single protected loom.
• Direct-fit compatibility spans LP4, LP6, LP-LT, and LP-SRT housings via standardized straight-pipe plugs that erase universal adapter guesswork and maintain consistent illumination levels.
• Tinned copper conductors mated with IP67-sealed Deutsch-style terminals outperform standard rubber boots in salt air, mud, and deep-wading conditions, preventing oxidation-related flicker over years of trail use.
• Space-saving 12-inch by 10-inch by 8-inch relay housing weighs only 6 pounds, preserving payload margins while allowing secure under-dash, glovebox, or engine-bay installation with double-sided tape or machine screws.
• Kin-lock keyed sockets block reverse polarity insertion and shake-off disconnects during aggressive maneuvering, letting you map routes and tighten fasteners without stopping mid-build.
• Aluminum thermal bus bar inside the control block dissipates heat efficiently, solving the widespread issue of LED dimming when multiple high-output units run simultaneously.
• Universal 2006–current chassis support covers GM Silverado, Ford F-Series, Toyota Tacoma, Jeep Gladiator, and Dodge RAM platforms, all protected by a lifetime limited warranty against manufacturing defects.