ICON 3.0 Stage 3 Coilover System for 2022–2025 Toyota Tundra

The fully adjustable 1.25‑ to 3.25‑inch lift range combined with compact dual‑chamber CDXS shock technology transforms factory suspension geometry, eliminating wheel hop and supporting aggressive tire profiles without chassis modification.

• CNC Billet Aluminum Body & Reservoir: Machined housing and integrated nitrogen precharged dampers provide rapid heat rejection during repeated compressions, maintaining consistent damping on desert hauls, rocky ledges, and loaded daily driving.
• Direct O.E. Mount Replacement: Engineered to bolt directly onto 2022–2025 Toyota Tundra factory mounting points; eliminates steering knuckle binding, cross‑pin stress, and alignment drift while preserving proper pinion angles.
• Adjustable Coil Springs & Preload Perches: Allows precise ride‑height tuning between 1.25 and 3.25 inches over stock, enabling ground‑clearance optimization for 35‑inch tires or reduced travel for highway stability.
• Extended Bump Stop Integration: Includes molded polyurethane bump stops sized for maximum droop travel, preventing metal‑to‑metal contact during hard impacts and protecting axle shafts, brake lines, and transfer cases.
• Heavy‑Duty Corrosion Shield: Industrial powder coating and sealed pivot bushings insulate internal valving and bearings from abrasive dust, road salt, and freshwater submersion during trail recovery operations.
• Stage‑Specific Valve Tuning: Factory calibrations balance soft initial compliance with progressive load support, reducing bottomouts on washboard surfaces while maintaining predictable handling under payload conditions.

Installation requires no cutting, trimming, or fabrication, though a post‑installation four‑wheel alignment is recommended once lift parameters are locked. Supported by ICON’s limited lifetime warranty against seal failures, fluid leaks, and structural finish defects when mounted within specified torque limits.