ICON Interchangeable Coilover Boxing Kit for 2022-2024 Toyota Tundra 6-Inch Stage 6 Systems

Precision-calibrated to replace compromised OEM hardpoints, these billet mounting brackets lock in factory-aligned control arm geometry, eliminate suspension chatter, and enable rapid coilover interchange without re-adjusting bump stops or tie rods.

• 6061-T6 Billet Aluminum Fabrication: CNC-milled housings resist bending, cracking, and galvanic corrosion far exceeding stamped-oem steel brackets or lower-grade 6xxx alloys.
• Direct-Fit Frame Integration: Matched precisely to 2022-2024 Toyota Tundra frame rails, utilizing existing mounting holes with zero cutting, drilling, or fabrication required.
• True Interchangeable Pocket Design: Geometry engineered to accept any ICON Stage 6 shock body or coilover assembly, allowing weekend trail rigs to swap damping configurations in minutes instead of hours.
• Rigidity & NVH Suppression: Tight-tolerance pockets paired with injected urethane isolation pads suppress metal-on-metal contact noise while preventing flex-induced misalignment over rock gardens.
• Full-Travel Load Capacity: Reinforced mounting shoulders and thickened load-bearing flanges handle sustained compression and rebound forces generated by oversized tires, winches, and expedition cargo.
• Complete Bolt-On Hardware: Ships with specification torque-rated fasteners, grade-8 nuts, spacers, and alignment shims pre-selected for a clean 6-inch stance and corrected steering geometry.

Fear of poor fitment or premature failure rarely applies here because every bracket undergoes virtual stress testing and real-world cycle validation before leaving the facility. The machined surfaces maintain precise bearing alignment season after season, while the anodized exterior resists abrasive dust, road salt, and UV degradation. Installed using straightforward turn-key procedures, the kit pairs seamlessly with your existing Stage 6 coilover bodies and maintains correct castor, toe, and pinion angles throughout full suspension articulation. Backed by the manufacturer’s lifetime limited warranty against casting flaws, weld separations, and anodize peeling, this mounting system locks into place and stays rigid mile after mile.